Home > Datsun Chassis > R33 RB25DET to ANY DATSUN Stand-Alone Wiring Service

R33 RB25DET to ANY DATSUN Stand-Alone Wiring Service

R33 RB25DET to ANY DATSUN Stand-Alone <font color="red"><u>Wiring Service</u></font>

Product Description

This Wiring Service and conversion only applies to the R33 RB25DET engine installed into any Datsun non EFI chassis.

NOTE: This is a wiring service. You must send in your old harness for modification.

Additional Images

Engine: R33 RB25DET

- Any RB25DET engine from a R33 Skyline GTS-T or Stagea

Chassis: Datsun

- Any 240 / 260 / 280 Datsuns

- Any stand-alone application for the RB25DET Engine

What we will need from you:

- Uncut RB25DET Main Engine Harness from the JDM engine.

- A note with: Return Address, Phone number, Email, Car info

- A note describing any problems or concerns

The service we will provide you with:
- A shortened RB25DET harness to fit the Chassis properly
- Fuse Block and Relay system installed for proper ECCS ON and OFF operation with ECU Memory retention
- Fuel Pump output wire that hooks directly into the pump
- Power wire with appropriate fuses, battery terminal and 10 feet length to connect to the battery
- Ignition Input wire from Ignition Key
- Nissan consult connector
- OUTPUT connections for ECU tachometer signal, Check engine light, Engine Temp (Nissan dash signal)
- All needed plugs are replaced, wires extended, and electrically insulated
- All connections are soldered and shrink wrapped together, No WIRE NUTS, TWISTED WIRES or CRIMP CONNECTORS.
- Tech support for our customers 7 days a week

Wiring Specialties