Wiring Specialties Pre-Made S13 SR20DET ZENKI into DATSUN Engine Harness

This Wiring Specialties Engine Harness is designed for a direct drop-in installation into any year DATSUN with an S13 SR20DET engine. Each Pre Made Harness will save you time, improve engine performance, give your engine bay a factory look and comes equipped with our Turn Key Start-Up Guarantee!

BUILT TO ORDER

* For AEM MAP conversion, please indicate the location of the AIT and the MAP sensors on the engine/piping in the NOTES section when ordering.

Additional Images

Engine: S13 SR20DET  

- Any Redtop from 1990-1993.5 Silvia or 180sx

- Any Blacktop from 1994-1996 180sx

- Supports ECU - 62, 63, E5, E4 See example of ECU CODE

Chassis: ANY DATSUN  

- 1200, 1500, 1600, 2000, 510, 240Z, 260Z, 280Z, 280ZX and many more!

Engine Harness Includes:

- Fuse Block and Relay system installed for proper ECCS ON and OFF operation with ECU Memory retention

- Fuel Pump output wire that connects directly to the pump

- Power wire with appropriate fuses, battery terminal and 10 feet length to connect to the battery

- Ignition Input wire from Ignition Key

- Nissan consult connector

- OUTPUT connections for ECU tachometer signal, Check engine light, Engine Temp (Nissan dash signal)

Engine Harness Features:

- Brand new wiring and connectors

- Fuse and Relay Blocks

- Support the OEM Consult port

- Improved grounding routing by addition of internal cross-grounding

- OEM connector specs (no cheap aftermarket connectors that fall apart)

- Designed for a factory-like installation and fit and finish for ANY DATSUN

- Works with aftermarket intakes

- Fully tested after production for an easy plug-and-play replacement

- Turn Key ENGINE START Guarantee
- Tech support for our customers 7 days a week.