LS1 Knock Sensor Interface Connector

LS1 Knock Sensor Interface Connector. This connector is located on the main EFI harness and connects to the LS Gen3 knock sensor subharness.

Connector is available as:

• Pigtail - Fully assembled with 3 inches of wire. Select this if you want to attach bare wire to bare wire.
  
• Housing - Only the plastic housing parts. Select this if you want to swap over the pinned wires from a damaged housing to a new housing.
  
• Parts - Not assembled, comes with housing, crimp-on wire terminals and wire seals.  Select this if you want to crimp new pins on and then assemble the connector.